PSI Tennessee CMC-Full Mechanical Contractor Certification Package

$1,449.47

Vendor: brown-states

Product type: Packages

To be certified the Tennessee Business and Law Exam must be passed.

The exam consists of 120 questions and you get 325 minutes to complete the test. the minimum required passing score is 73%. 

The reference material listed below was used to prepare the questions for this examination. The examination may also contain questions based on trade knowledge or general industry practices. Except for Code books, you can base your answers on later editions of references as they become available. For Code questions, the examinations will be based only on the edition of the Code book that is listed. 

Candidates may use a silent, nonprinting, non-programmable calculator in the examination center.

This examination is OPEN BOOK.

Reference Materials:

OSHA CONSTRUCTION STANDARDS & REGULATIONS (29 CFR 1926)

2012 International Mechanical Code

2012 INTERNATIONAL FUEL GAS CODE

2012 International Plumbing Code

NFPA 13: Installation of Sprinkler Systems Pipefitters Handbook 3rd Revised ed. Edition

2006 International Plumbing Codes Handbook,

Modern Refrigeration and Air Conditioning 20th ed

Air Duct Sizing Calculator

HVAC Duct Construction Standards - Metal and Flexible

CARRIER System Design Manual Part 3: Piping Design Commercial Load Calculation for

Small Commercial Buildings,

Manual N

Manual J: Residential Load Calculation, 8th edition-Version 2

Candidates are responsible for bringing their own references to the examination center. Reference materials may be highlighted, underlined, and/or indexed prior to the examination session. However, references may not be written in. Any candidate caught writing in the references during the examination will be reported to the Board. Furthermore, candidates are not permitted to bring in any additional papers (loose or attached) with their approved references. References may be tabbed/indexed with permanent tabs only. Temporary tabs, such as Post-It notes, are not allowed and must be removed from the reference before the exam will begin. Scratch paper will be provided for calculations. Candidates will NOT be permitted to remove from the examination room ANY material that has been written on. (This would include books).

|title=mandatory business exam|psi-tennessee-business-and-law-management-exam-certification-package|title=Reference Materials|osha-construction-standards-regulations-29-cfr-1926|uglys-electrical-references-2014|2012-international-mechanical-code|2012-international-fuel-gas-code|2012-international-plumbing-code|nfpa-13-installation-of-sprinkler-systems|pipefitters-handbook-3rd-edition|2006-international-plumbing-code-2nd-printing-indiana-edition|modern-refrigeration-and-air-conditioning-20th-ed|air-duct-sizing-calculator|hvac-duct-construction-standards-metal-and-flexible|carrier-system-design-manual-part-3-piping-design|commercial-load-calculation-for-small-commercial-buildings-manual-n|manual-j-residential-load-calculation-8th-edition-version-2|title=Application Assistance|application-service|

Need help Finding a Product or assistance with an Order ?

3 ways to get support:

To Top