PSI Tennessee CMC-C-Mechanical-HVAC/Refrigeration Contractor Certification Package

$1,095.74

Vendor: brown-states

Product type: Packages

the exam consists of 100 questions and you get 260 minutes to complete the test. the minimum required passing score is 73%.

The reference material listed below was used to prepare the questions for this examination. The examination may also contain questions based on trade knowledge or general industry practices. Except for Code books, you can base your answers on later editions of references as they become available. For Code questions, the examinations will be based only on the edition of the Code book that is listed.

Candidates may use a silent, nonprinting, non-programmable calculator in the examination center.

This examination is OPEN BOOK.

The following reference materials are allowed in the examination center:

International Mechanical Code, 2006

Manual J - Residential Load Calcs, reprinted 2006, Eighth Full Edition

International Fuel Gas Code, 2006

Pipefitters Handbook

Modern Refrigeration and Air Conditioning

An air duct sizing calculator wheel, slide or similar device

HVAC Duct Construction Standards, Metal and Flexible, 2005, 3rd edition

Ugly's Electrical References, George V. Hart, 2008, 2011, or 2014

Carrier System Design Manual Part 3

Code of Federal Regulations - 29 CFR Part 1926 (OSHA

Candidates are responsible for bringing their own references to the examination center. Reference materials may be highlighted, underlined, and/or indexed prior to the examination session. However, references may not be written in. Any candidate caught writing in the references during the examination will be reported to the Board. Furthermore, candidates are not permitted to bring in any additional papers (loose or attached) with their approved references. References may be tabbed/indexed with permanent tabs only. Temporary tabs, such as Post-It notes, are not allowed and must be removed from the reference before the exam will begin. Scratch paper will be provided for calculations. Candidates will NOT be permitted to remove from the examination room ANY material that has been written on. (This would include books).

|title=mandatory business exam|psi-tennessee-business-and-law-management-exam-certification-package|title=Reference Materials|osha-construction-standards-regulations-29-cfr-1926|uglys-electrical-references-2014|pipefitters-handbook-3rd-edition|modern-refrigeration-and-air-conditioning-20th-ed|air-duct-sizing-calculator|hvac-duct-construction-standards-metal-and-flexible|carrier-system-design-manual-part-3-piping-design|manual-j-residential-load-calculation-8th-edition-version-2|2006-international-mechanical-code|2006-international-fuel-gas-code|title=Application Assistance|application-service|

Need help Finding a Product or assistance with an Order ?

3 ways to get support:

To Top